6.2
Opening the burner
6.2.1
To open the burner
To open the burner proceed sa follows:
switch off the electrical power;
loosen screws 1) and withdraw the cover 2);
disengage the swivel coupling 7) from the graduated sector;
disconnect the light-oil pipes 8);
remove screws 3) and pull the burner back by about 4" on the
slide bars. disconnect the electrode leads.
Install the extension bars 31) Fig. 1, page 8 and re-screw the
2 screws and the safety plate Fig. 11, page 18.
Pull the burner fully back.
Now extract the internal part 5) after having removed the screw 6).
D11003
Maintenance
1
2
37
GB
6.2.2
To close the burner
To close the burner proceed sa follows:
push the burner until it is about 4" from the sleeve;
re-connect the leads.
Remove the extension bars 31)(Fig. 1, page 8).
Slide in the burner until it comes to a stop;
refit screws 3) and pull the leads gently out until they are
slightly stretched;
re-couple the swivel coupling 7) to the graduated sector;
reconnect the light-oil pipes.
Re-screw the 2 screws and the safery plate Fig. 11, page 18.
3
4
8
6
8
5
Fig. 52
20031446