NETGEAR R7000 User Manual page 114

The screen adjusts:
The router automatically detects the information in the following fields:
Router's IPv6 Address on WAN. This field shows the IPv6 address that is acquired
•
for the router's WAN (or Internet) interface. The number after the slash (/) is the length
of the prefix, which is also indicated by the underline (_) under the IPv6 address. If no
address is acquired, the field displays Not Available.
Router's IPv6 Address on LAN. This field shows the IPv6 address that is acquired
•
for the router's LAN interface. The number after the slash (/) is the length of the prefix,
which is also indicated by the underline (_) under the IPv6 address. If no address is
acquired, the field displays Not Available.
In the Login field, enter the login information for the ISP connection.
3.
This is usually the name that you use in your email address. For example, if your main
mail account is JerAB@ISP.com, you would type JerAB in this field. Some ISPs (like
Mindspring, Earthlink, and T-DSL) require that you use your full email address when you
log in. If your ISP requires your full email address, type it in this field.
In the Password field, enter the password for the ISP connection.
4.
In the Service Name name field, enter a service name.
5.
If your ISP did not provide a service name, leave this field blank.
Note:
The default setting of the Connection Mode field is Always on to provide
a steady IPv6 connection. The router never terminates the connection. If the
connection is terminated, for example, when the modem is turned off, the router
attempts to reestablish the connection immediately after the PPPoE connection
becomes available again.
Specify how the router assigns IPv6 addresses to the devices on your home network (the
6.
LAN) by selecting one of the following radio buttons:
R7000 Smart WiFi Router
Advanced Settings
114