Usage Of Child Lock; Rinse Aid Indicator Setting; Starting Your Machine - Gram OM 62-26 T Instruction Manual

machine. You must refill the rinse aid
container when the rinse aid indicator
comes on.
WARNING:
If the Rinse Aid Indicator is set to
(OFF), rinse aid indicator will never
come on even if the rinse aid container
is empty.

Rinse Aid Indicator Setting

•
When your machine is switched
off, press Half Load
and then On / Off button (1) to
switch it on.
•
Hold Half Load
pressed and release On / Off
button (1).
•
Keep Half Load
pressed for three seconds more.
•
Rinse Aid Indicator (
and the stored rinse aid indicator
status of your machine appears on
the display in the format of "ON" or
"OFF".
•
You can change the status of the
indicator as "ON" or "OFF" with
Start / Pause / Cancel button (2).
If you switch off the machine with
"On/Off" button (1) when the status
is "ON", then the rinse aid indicator
will come on when the rinse aid
level in your machine becomes
low while the machine is in use.
If you switch off the machine
with "On/Off" button (1) when the
status is "OFF", then the rinse aid
indicator will never come on.
button (5)
button (5)
button (5)
10) comes on
27 GB

Starting Your Machine

•
Plug the mains plug into the wall
socket.
•
Open the tap.
•
Open the door.
•
Place the dishes.
•
Check if the upper and lower
impellers rotate freely.
•
Put sufficient amount of detergent
in the detergent dispenser and
close its lid.
•
Press On/Off button.
•
Check if the salt and rinse aid
warning indicators (9,10) light and
add salt and/or rinse aid if needed.
•
Determine your washing program
with the aid of the Program
Data and Table of Average
Consumption Values.
•
You can select the determined
washing program by pressing
program selection button (4).
•
You can see the program time in
the Remaining Time Indicator (11).
•
If necessary, you can change your
washing program as you prefer
by means of the Add Function
Buttons (6, 5).
•
Start the program by pressing the
Start / Pause / Cancel button (2).
WARNING:
Pay attention not to open the door
of the machine when it is running.
Stop the machine by pressing Start /
Pause / Cancel button (2) if you have
to open the door. Then, open the door
of your machine. There may be a rush
of vapor when you open the door of
your machine; be careful. Close the
door and press Start/Pause/Cancel
button (2) again. Program will resume
running.