End Time - Beko B3WF U 4721 W User Manual

cancelled or the step is complete. If the
function is not cancelled, it will be active in
the subsequent washing cycles as well.
• Extra Rinsing
This function can be selected by pressing
and holding the related auxiliary function
button for 3 seconds.
This function enables the product to make
additional rinsing in addition to the one
already made after the main wash. Thus,
the risk for sensitive skins (babies, allergic
skins, etc.) to be effected by the minimal
detergent remnants on the laundry can be
reduced.
• Child Lock
Use Child Lock function to prevent children
from tampering with the machine. Thus you
can avoid any changes in a running pro-
gramme.
You can switch on and off the ma-
chine with On / Off button when the
Child Lock is active. When you
switch on the machine again, pro-
gramme will resume from where it
has stopped.
When the Child Lock is enabled, an
audio warning will be given if the
buttons are pressed. Audio warning
will be cancelled if the buttons are
pressed five times consecutively.
To activate the child lock:
Press and hold the related auxiliary func-
tion button for 3 seconds. After the count-
down as "3-2-1" on the display is over, Child
Lock symbol appears on the display. When
this warning is displayed, you can release
the Auxiliary Function button 3.
To deactivate the child lock:
Press and hold the related auxiliary func-
tion button for 3 seconds. After the count-
down as "3-2-1" on the display is over, Child
Lock symbol disappears.

6.9 End Time

Time display
When the end time function is selected, the
remaining time until the programme starts
is shown in hours such as 1h, 2h, and the
remaining time to complete the programme
after your programme starts is shown in
hours and minutes as in the 01:30 example.
Programme duration may differ
from the values in section "Pro-
gramme and consumption table"
depending on the water pressure,
water hardness and temperature,
ambient temperature, amount and
the type of laundry, auxiliary func-
tions selected and the changes at
the mains voltage.
After a certain period of time after
the end time function is activated,
the machine goes into standby
mode and some LEDs on the
screen turn off. If there is any user
input, the LEDs will turn on again.
With the End Time function, the end time of
the programme may be set up to 24 hours.
After pressing End Time button, the pro-
gramme's estimated ending time is dis-
played. If the End Time is set, End Time in-
dicator is illuminated.
In order for the End Time function is activ-
ated and the programme is completed at
the end of the specified time, you must
press Start/Pause button after adjusting
the time.
EN / 28