Installing The Stand - Hisense 85R7 Quick Setup Manual

Installing the Stand

CAUTION
Be sure to disconnect the A/C power cord before removing a base stand or
installing wall mount brackets.
The screen display is very fragile, and must be protected at all times when installing
the base stand. Be sure that no hard or sharp object, or anything that could scratch
or damage the screen display, comes into contact with it. DO NOT exert pressure
on the front of the TV at any time because the screen could crack.
Follow the illustrations and textual instructions below to complete the installation steps:
Two people and above are required.
1. Remove buckles on both sides of the carton box , take out the upper box and
cushion, place cushions parallel with the ground with their grooves face-up, the
distance between two cushions should be less than that of the base holes.
2. Two people from each side hold the top of the television using one hand, support
its bottom or hold small handles using the other hand to lift the television together,
move the television vertically to the grooves in the upper cushions.
3. One person holds the television from the front side, the other person takes out 4
screws(M5×16) to install the stand in the following steps: take out the cable clamp
in the stand, secure the stand with screws and then restore the cable clamp to its
original place. After installation, remove the handles and move the television to
designated spot.
Notes: According to practical needs, both A-type(L1R1) span and B-type(L2R2) span
Installing the Stand
2
Big handles
Small handles
Upper cushions