Installing The Stand Or Wall Mount Bracket - Hisense 43A7100F Quick Setup Manual

Installing the Stand or Wall mount bracket

CAUTION
Be sure to disconnect the AC power cord before installing a stand or wall mount
brackets.
The display on your TV is fragile. Make sure the TV screen is not scratched or
damaged by hard objects or from pressure.
After the installation is complete, make sure the TV is steady on a table or firmly
attached to a wall mount, before removing all protective film, if any.
Installing the Stand
Follow the illustrations and textual instructions below to complete the installation steps:
1. Carefully place your TV face-down on a soft, flat surface to prevent damage to the
TV or scratching to the screen.
2. Remove the Base Stand from the accessory bag and then insert the stands into the
bottom slots of the TV.
3. Secure the Base Stand to the TV with the screws in accessory tightly.
43"/50"/55"
65"
Attention: According to the size of the TV supporting surface, you can select one of
the base stand installation patterns, as shown in the figure.
Base Stand
Base Stand
Base Stand
Screws: (M4×16) × 4 (43")
(M4×12) × 4 (50"/55")
Screws:
(M5×12) × 4
2
Base Stand