Repeating Chapters; Programming Playback Sequence - PROTRON TPL-C01 User Manual

OMTPLC01.book Page 12 Thursday, September 15, 2005 10:19 AM
Playing DVDs
3. Enter the desired location.
4. Press .

Repeating Chapters

Press REPEAT to cycle through the repeat modes: Off, Chapter, Title, and A–B. You can repeat an
arbitrary section of video using the A–B repeat mode.
To repeat an arbitrary selection:
1. Press REPEAT until "REPEAT A–" shows to mark the beginning of the section.
2. Press REPEAT once more to mark the end of the section. "REPEAT A–B" will display on the
screen.
The section will begin repeating and will continue until you press REPEAT again.

Programming Playback Sequence

The PROGRAM button brings up the Program menu, which allows you to program playback
sequence. There are 16 slots available.
To program playback sequence:
1. Press PROGRAM to bring up the Program
menu.
2. Select the first slot using the arrow controls,
and enter the desired title (under the "T"
column) and chapter (under the "C" column)
numbers using the keypad.
3. Proceed in the same manner through the next
slots until the whole sequence is
programmed.
4. Select "PLAY" using the arrow controls and then press
Select "CLEAR" and press
P RO G
T
1 – – :
2 – – :
3 – – :
4 – – :
to clear the playback sequence and start over.
12
C T C T C
– – 5 – – : – – 9 – – : – – 1
– – 6 – – : – – 1 0 – – : – – 1
– – 7 – – : – – 1 1 – – : – – 1
– – 8 – – : – – 1 2 – – : – – 1
P L A Y C L E A R
to begin playing back the sequence.
T C
3 – – : – –
4 – – : – –
5 – – : – –
6 – – : – –