Using Your Display For The First Time; Setting Up Digital Television Channels; Setting Up Analog Television Channels - PROTRON PLTV-4250 User Manual

OMPLTV4250.book Page 11 Thursday, February 16, 2006 10:22 AM

Using Your Display for the First Time

When you turn on your LCD for the first time, you will need to set up the display for proper
operation by scanning the television spectrum for available channels.

Setting up Digital Television Channels

Once the HDTV signal is connected to the display, you should scan all channels to find strong
signals. This will make it much easier to navigate through the channels.
To scan all channels:
1. Turn the display on using the POWER button.
2. Press SOURCE until the signal source is set to DTV.
3. Press MENU to bring up the On-Screen Display
(OSD).
4. Press the
shows.
5. Press until Time Zone is highlighted and then press
until the correct time zone is selected.
6. Press until Auto Scan is highlighted and then press
ENTER to begin scanning for available television
channels.

Setting up Analog Television Channels

Once an analog television signal is connected to the display, if you are connecting directly to a
wall jack or antenna, you should scan the signal spectrum to weed out channels with insufficient
signal strength. This will make it much easier to navigate through the channels.
To scan the signal spectrum:
1. Turn the display on using the POWER button.
2. Press SOURCE until the signal source is set to TV.
3. Press the MENU button to bring up the On-Screen
Display (OSD).
button until the DTV General menu
Contrast
Brightness
Saturation
Hue
Sharpness
Phase
Flesh Tone
Color Temperature
Video
Contrast
Brightness
Saturation
Hue
Sharpness
Phase
Flesh Tone
Color Temperature
Video
11
50
50
50
50
30
20
ON
Warm
Select Select Exit Exit
MENU
50
50
50
50
30
20
ON
Warm
Select Select Exit Exit
MENU