Checking Wiring And Settings - MSA fieldserver ProtoNode FPC-N64 Operating Manual

10.3 Checking Wiring and Settings

No COMS on the Modbus RTU side. If the Tx/Rx LEDs are not flashing rapidly then there is a COM issue. To fix this
problem, check the following:
• Visual observations of LEDs on the ProtoNode. (Section
• Check baud rate, parity, data bits, stop bits.
• Check device address.
• Verify wiring.
• Verify the device was listed in the Web Configurator (Section
No COMS on the Modbus TCP/IP side. To fix this problem, check the following:
• Visual observations of LEDs on the ProtoNode. (Section
• Check device address.
• Verify wiring.
• Verify the device was listed in the Web Configurator (Section
Field COM problems:
• Visual observations of LEDs on the ProtoNode. (Section
• Verify wiring.
• Verify IP Address setting.
NOTE: If the problem still exists, a Diagnostic Capture needs to be taken and sent to support. (Section
Taking a FieldServer Diagnostic
10.4 LED
10.4 LED
10.4 LED
Capture)
Hunter Fans ProtoNode FPC-N64
Functions)
9.3 Setting Active Profiles).
Functions)
9.3 Setting Active Profiles).
Functions)
10.5
38