MSA fieldserver ProtoNode FPC-N64 Operating Manual page 3

1. Record the information about the unit. (Section
2. Check that the ProtoNode and customer device COM settings match. (Section
Communications)
3. If connecting to a serial device:
Connect the ProtoNode 3 pin RS-485 R1 port to the RS-485 network connected to each of the devices. (Section
Device Connections to
4. If using a serial field protocol:
Connect the ProtoNode 3 pin RS-485 R2 port to the field protocol cabling (Section
Serial Network).
5. Connect power to ProtoNode 3 pin power port. (Section
6. Connect a PC to the ProtoNode via Ethernet cable. (Section
7. Setup Web Server Security and login via web browser. (Section
8. Configure the ProtoNode to connect to the local network. (Section
9. Integrate the ProtoNode with the FieldServer Manager or opt out. (Section
FieldServer Manager)
10. Use a web browser to access the ProtoNode Web Configurator page to select the profile of the device attached to the
ProtoNode and enter any necessary device information. Once the device is selected, the ProtoNode automatically
builds and loads the appropriate configuration. (Section
3
Quick Start Guide
2.1 Record Identification
ProtoNode)
Hunter Fans ProtoNode FPC-N64
Data)
2.3 Configuring Device
3.2 Wiring Field Port to RS-485
4 Power up the Gateway)
5 Connect the PC to the
6 Setup Web Server
7 Setup Network)
8.1 Choose Whether to Integrate the
9 Configure the ProtoNode)
3.1
Gateway)
Security)