Ethernet 1 And Ethernet 2 Network Settings - Lan Mode - MSA fieldserver ProtoNode FPC-N64 Operating Manual

Interfacing hunter fans products
Hide thumbs Also See for fieldserver ProtoNode FPC-N64:
Table of Contents

Advertisement

7.3
Ethernet 1 and Ethernet 2 Network Settings – LAN Mode
• Check that the Mode is set to LAN, if not click LAN to change the ETH 2 port to LAN mode.
• Enable DHCP to automatically assign IP Settings or modify the IP Settings manually as needed, via these fields: IP
Address, Netmask, Gateway, and Domain Name Server1/2.
NOTE:    If connected to a router, set the Gateway to the same IP Address as the router.
• Click Save to record and activate the new IP Address.
• Connect the FieldServer to the local network or router.
NOTE:    If the webpage was open in a browser, the browser will need to be pointed to the new IP Address of the
FieldServer before the webpage will be accessible again.
19
Hunter Fans ProtoNode FPC-N64

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the fieldserver ProtoNode FPC-N64 and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents