Table Of Contents - MSA fieldserver ProtoNode FPC-N64 Operating Manual

Contents
1 Introduction
1.1 ProtoNode Gateway
2 Setup for ProtoNode
2.1 Record Identification Data
2.2 Point Count Capacity and Registers per Device
2.3 Configuring Device Communications
2.3.1 Set Node-ID for Any Device Attached to the ProtoNode
2.3.2 Set IP Address for Any Ethernet Device Connected to the ProtoNode
3 Interfacing ProtoNode to Devices
3.1 Device Connections to ProtoNode
3.2 Wiring Field Port to RS-485 Serial Network
3.3 Bias Resistors
3.4 Termination Resistor
4 Power up the Gateway
5 Connect the PC to the Gateway
5.1 Connecting to the Gateway via Ethernet
5.1.1 Changing the Subnet of the Connected PC
6 Setup Web Server Security
6.1 Navigate to the Login Page
6.2 Login to the FieldServer
6.3 Select the Security Mode
6.3.1 HTTPS with Own Trusted TLS Certificate
6.3.2 HTTPS with Default Untrusted Self-Signed TLS Certificate or HTTP with Built-in Payload Encryption
7 Setup Network
7.1 Navigate to the Network Settings
7.2 Routing Settings
7.3 Ethernet 1 and Ethernet 2 Network Settings - LAN Mode
7.4 Ethernet 2 Network Settings - WAN Mode
8 MSA Grid - FieldSever Manager Setup
8.1 Choose Whether to Integrate the FieldServer Manager
8.2 User Setup
8.3 Registration Process
8.4 Login to the FieldServer Manager
9 Configure the ProtoNode
9.1 Navigate to the ProtoNode Web Configurator
9.2 Select Field Protocol and Set Configuration Parameters
9.3 Setting Active Profiles
9.4 Verify Device Communications
9.5 BACnet: Setting Node_Offset to Assign Specific Device Instances
9.6 How to Start the Installation Over: Clearing Profiles
Hunter Fans ProtoNode FPC-N64
6
6
7
7
7
7
7
7
8
8
8
9
10
11
12
12
12
13
13
13
15
16
16
17
17
18
19
20
21
21
22
24
28
30
30
31
32
33
34
35
4