Table of Contents
Advertisement
Hotplate
Extended
cooking zone
Notes
¡ Dark areas in the glow pattern of the hotplate are
part of the technical design. They do not affect the
functionality of the hotplate.
¡ The hotplate regulates the temperature by switching
the heat on and off. The heat may also switch on
and off when at the highest setting.
¡ With multi-circuit hotplates, the heating of the inner
filament circuits and the heating of the activations
may switch on and off at different times.
– This protects easily damaged components from
overheating.
– The appliance is protected against electrical
overload.
– Better cooking results are achieved.
5 Basic operation
5.1 Switching the hob on or off
The main switch is used to switch the hob on and off.
If you switch the appliance back on again within
4 seconds after switching off, the hob will start up with
the previously stored settings.
5.2 Switching on the hob
Touch
.
▶
a The indicator lamp above
a The displays for the controls and the heat setting
displays
light up.
a The hob is ready for use.
a The two front hotplates are selected.
a The two rear heat setting indicators
brightly.
5.3 Switching off the hob
The hob will switch off automatically when all hotplates
have been switched off for a while (10-60 seconds).
Touch
.
▶
a The indicator lamp above
a The displays go out.
a All hotplates are switched off.
a The residual heat indicator remains on until the hot-
plates have cooled down sufficiently.
5.4 Setting the hotplates
To set a hotplate, it has to be selected.
The left-hand hotplates are selected with the control
panel on the left side and the right-hand hotplates with
it on the right.
Heat setting
1
Lowest setting
9
Highest setting
.
Every heat setting has an intermediate
setting, e.g. 4.5.
Activating and deactivating
Touch
.
lights up.
light up
goes out.
4.5 Residual heat indicator
The hob has a two-stage residual heat indicator for
each hotplate. Do not touch the hotplate while the re-
sidual heat indicator is lit up.
Display
Meaning
The hotplate is so hot that you can
keep small dishes warm or melt cook-
ing chocolate.
The hotplate is hot.
5.5 Selecting heat settings
Requirement: The hob is switched on.
To select a hotplate, touch the heat setting indicator
1.
.
a
lights up brightly on the heat setting display.
Select the required heat setting on the control panel.
2.
a The hotplate is switched on.
5.6 Changing heat settings
Select the hotplate with the heat setting indicator.
1.
Select a heat setting on the control panel.
2.
5.7 Switching off a hotplate
If you have switched off a hotplate, the residual heat in-
dicator appears after approx. 10 seconds.
Select the hotplate with the heat setting indicator.
1.
Select 0 on the control panel.
2.
Note: The hotplate last selected remains activated. You
can adjust the hotplate without selecting it again.
Basic operation en
7
Advertisement
Table of Contents
