Battery pack
Remove the I/O bracket
Make sure the following FRU (or CRU) has been removed.
"Remove the lower case" on page 30
Step 1.
Disconnect the battery pack cable from the system board.
Attention: Use your fingernails to pull the connector to unplug it. Do not pull the cable.
Step 2.
Remove two screws and then remove the I/O bracket.
Figure 8. Remove two screws and remove the I/O bracket
Screw specifications
M2.5 x L4
M2 x L3
Go to
https://support.lenovo.com/partslookup
part:
I/O bracket
Remove the 5G cable bracket
Make sure the following FRUs (or CRUs) have been removed.
"Remove the lower case" on page 30
"Remove the heat sink" on page 31
Step 1.
Remove one screw and then remove the 5G cable bracket.
Number of screws
1
1
to look up the Lenovo part number of the following replacement
.
Chapter 4
Removing a FRU or CRU
33