Maintenance And Cleaning; Emptying And Cleaning The Clean Water Tank - RCm BIT 391CB/3 BIT 391C Use And Maintenance

11.1 MAINTENANCE AND
WARNING:
For information and warnings regarding
maintenance or cleaning, follow the in-
formation given in the "General warnings
during maintenance" in chapter 1 in this
manual.
11.1.a - Emptying and cleaning the
WARNING:
At the end of the washing operations, it is
compulsory to drain and clean the clean
water tank to prevent deposits or scal-
ing.
After draining the recovery water tank, drain
the clean water tank as follows:
- Position the machine over a drain outlet.
- Unscrew the cap (1) of the connector (2)
and let it completely drain the water.
- Wash the inside of the tank, leaving the
drain cap open and adding clean water
through the front opening.
- After cleaning replace the cap (1) and
3
screw on the connector (2) checking the
condition of the gasket inside the cap.
CLEANING
OPERATIONS TO
PERFORM DAILY
clean water tank (Fig. 14)
1
2
EN-19
EN
Fig. 14