Operation; Checks Before Use - RCm BIT 391CB/3 BIT 391C Use And Maintenance

9.1.a -
- Check that the exhaust tube (1) of the re-
covery tank is properly coupled and prop-
erly sealed.
- Check that the squeegee water aspira-
tion hose (2) is correctly inserted in the
recovery tank.
- Check that the connector (3) on the
squeegee (9) is not blocked and that the
hose is connected correctly.
- To check the status of the battery charge;
press the switch (4), controlling the LEDs
(5) indicator (only for version CB).
9.1.b - Preparing the machine and
- Set the button (4) to "I" or "II".
- Pull the lever (6) and release it, it lowers
the squeegee.
0
Working cycle:
- The machine can perform 4 working cy-
cles:
Drying only cycle:
- To perform the drying cycle only, set the
button (4) to "I" and set the button (7).
The aspirator starts up.
Brushing only cycle:
- To perform the brushing cycle only, set
the button (4) to "I" and press the levers
(8); when the levers (8) are released, the
brush comes to a halt.
Washing, brushing cycle:
- Set the button (4) to enable water supply
and brush rotation, then press the levers
(8) to start the cycle.
Washing, brushing, drying cycle:
- Set the button (4) to "II" to enable water
supply and brush rotation, then set the
button (7) to start up the aspirator, then
press the levers (8) to start the cycle.

9.1 OPERATION

(Figs. 11-12)

Checks before use

choosing the cycle
7
8
6
EN-15
EN
6
1
2
3
9
5
4
8
Fig. 11