Bahco BCL33IW1K1 Manual page 8

18v – cordless 1/2” impact wrench
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1
8. When you charge a new battery pack or a battery pack which has not been used for a long
period, it may not accept a full charge. This is a normal condition and does not indicate a
problem. You can recharge the battery pack fully after discharging it completely a couple of
times.
10. Please remove the battery from the unplugged charger for storage.
Fuel gauge LED display on machine
1. The machine has 3 steps green LED for indicating remaining battery capacity status by
press down trigger; LED will stay illuminated for 3 seconds. (by press down trigger if you
wanted to display battery capacity status once again).
indicates battery is over temperature.
Fuel gauge LED indication
LED 1 (green)
LED 1, 2 (green)
LED 1, 2, 3 (green)
The LED Light on the Charger
WARNING
1. Charger is plugged into a 100-240V a.c outlet only.
2. If the battery pack is too hot or too cold, the charger will not fast charge the battery pack
and the red Indicator light is "blinking". When the battery pack temperature returns to
between 0°C (32°F) and 50°C (122°F), The charger will automatically begin charging.
3. If both red and green indicator lights are "ON" the battery pack either does not comply or is
defective. Please contact your retailer.
4. Do not charge the battery pack in the rain, snow or high temperature environment.
5. Do not charge battery pack when environment temperature is below 0°C (32°F) or above
40°C (104°F)
4. Push the battery pack into place and make sure the red light on the
charger is "ON". The battery pack is now starting the charging cycle.
The battery pack is now ready for use.
6. Your new battery pack is not charged. You need to charge it before
use.
7. If you try to charge a battery pack from a just-operated machine,
sometimes the charging light will not come on. If this occurs, let the
battery pack cool for a while then re-insert it and try to charge again.
Battery Low (Red light stays illuminated)
Battery charged 100% (Green light stays illuminated)
Battery Pack malfunction (Red and Green lights stay illuminated)
RC Status
0% - 33%
34% - 66%
67%-100%
8

Advertisement

Table of Contents
loading

This manual is also suitable for:

Bcl33iw1

Table of Contents