Table of Contents
Advertisement
8-5. How to set louver lock (Louver fix)
1
UNIT
LOUVER
Push
(At the right side of the button) for
4 seconds or more during stop of the operation.
•
flashes.
2
UNIT
LOUVER
Push
(At the left side of the button) and
select the unit to be set.
• Every pushing the button, the unit No. changes.
UNIT No.
UNIT No.
1–1
UNIT No.
The fan of the selected unit rotates and the
louver swings.
3
Push temp. set
louver No. of which air direction is to be fixed.
• The selected louver swings.
[F1]
[F2]
4
Push TIMER SET
direction of the louver of which swinging you
do not want.
Code
0001
0004
∗ If selecting above and ..., there may be fear of
dewing in cooling time.
5
SET
Push
to determine the setup contents.
• When the setup was determined,
⎛
To set continuously the louver lock of the other unit,
⎜
⎜
repeat operations from 2 but from 3 to set the other
⎜
louver lock in the same unit, respectively.
⎝
6
TEST
Push
to finish the setup.
0001 to 0005
(Louver fixed position code)
∗ F1 displayed at the CODE No. on the remote
controller means that the 01 louver was selected
as shown in the figure.
UNIT No.
1–2
1–3
1–4
/
to display the
[F3]
[F4]
/
and select air
0002
0003
0005
mark goes on.
Louver
No.
Refrigerant pipe
Electric parts box
Drain pipe
NOTIFICATION
• Even if louver lock works, the louver temporarily
moves in the following cases.
1) During stop
2) At start of heating operation
3) During defrost operation
4) During thermostat OFF
8-6. How to clear louver lock
In the item 4 of the louver lock setup
procedure, set the air direction to 0000.
•
mark goes off.
The operations from 1 to 3, 5
and 6 are same as those of the
louver lock.
6. How to set contents of save operation
In combination with outdoor units before 4 series,
the displayed setup value exchanges, but the real
operation is "75% fixed".
1
SAVE
Push
for 4 seconds or more during
stop of the operation.
•
flashes.
2
UNIT
LOUVER
Push
and select the unit to be set.
• Every pushing the button, the unit No. changes.
The fan of the selected unit rotates and the
louver swings.
UNIT No.
1–1
⎞
⎟
⎟
3
⎟
Determine the capacity restricted value when
⎠
pushing the save button of TIMER SET
• Every pushing the button, the capacity re-
stricted value can be set at 1% interval in the
range between 100% and 50%.
∗ The setting at shipment is 75%.
4
SET
Push
and then push
- 77 -
03
04
01
Code 0000
(At the left side of the button)
UNIT No.
UNIT No.
1–2
1–3
UNIT No. 1–4
Setup value at saving
TEST
to finish the setup.
02
/
.
Advertisement
Table of Contents
Troubleshooting
