HIKVISION DS-E04NI-Q1 User Manual page 78

Configure PTZ Linkage
Video recorder can trigger the PTZ actions (e.g., call preset/patrol/pattern) when the alarm event,
or VCA detection events occur.
Steps
1. Go to Linkage Action interface of the alarm input or VCA detection.
2. Select PTZ Linkage.
3. Select the camera to perform the PTZ actions.
4. Select the preset/patrol/pattern No. to call when the alarm events occur.
Note
You can set one PTZ type only for the linkage action each time.
Configure Audio and Light Alarm Linkage
For certain network cameras, you can set the alarm linkage action as audio alarm or light alarm.
Before You Start
Ensure your camera supports audio and light alarm linkage.
●
Ensure the audio output and volume are properly configured.
●
Steps
1. Click Linkage Action.
2. Select audio or light as your desire.
3. Click Apply.
Note
If you require to set audio and light parameters, please log into the network camera via web
browser to configure them.
Network Video Recorder User Manual
Figure 6-25 PTZ Linkage
65