Download Print this page

New Holland ZDJE10095 Service Manual page 28

Advertisement

Engine - Install
1. Respect the tightening torques.
2. Connect the engine, with chains, to the hoist.
3. Refit the engine to the front axle-support assembly with
the radiator and cooler.
4. Before refitting the engine to the clutch box carefully
clean the mating surfaces and apply sealing compound
( 2 mm (0.08 in) diameter), according to the diagram
shown in Transmission housing - Reseal (21.114) .
5. Position the engine on the clutch casing and secure it
with the specific bolts.
6. Position and secure the retaining bracket between the
radiator and engine.
7. Secure the pipe joining the main tank to the secondary
one.
8. Position and secure the guard between the radiator and
engine.
9. Connect the air-conditioning system pipes to the con-
denser.
10. Insert the transmission oil radiator into its seat and
secure it.
11. Connect and secure the top and bottom sleeves to the
engine radiator.
12. Connect the steering cylinder control piping.
13. Connect the electrical connections of the secondary
tank fuel level and clogged air filter.
14. Position and secure the connecting pipes of the
cooler, turbocharger, air filter and oil vapour recircu-
lation.
15. Position and connect the transmission oil inlet pipe.
16. Position and secure the pipes of the transmission oil
filter support.
17. Connect the transmission oil cooler and front axle dif-
ferential lock pipes.
18. Carry out operation Drive shaft - Assemble (21.145)
Propeller shafts and guard, only installation
19. Connect the cooler and front axle differential lock
pipes.
20. For models fitted with brakes on the front axle it is nec-
essary to fill the relevant tank (see dedicated section
for the prescribed product and quantity) and bleed the
braking system.
21. Screw the plug on the rear transmission casing and fill
up with oil (see dedicated section for the prescribed
product and quantity).
22. Position and secure the ballast support.
23. Position and secure the ballast.
24. Install the cab as described in operation Cab - Install
(90.150).
Engine - Engine and crankcase
47888375 08/07/2016
10.1 [10.001] / 7

Advertisement

loading