Advertisement
Engine - Install
To refit the engine, proceed as follows:
1. Check condition of ball bearings pressed in flywheel,
replace in the event of excessive noise or binding. To
install a new bearing, pack lubricate with grease posi-
tion the clutch using tool 380000612 (Model TD5.65,
TD5.75 and TD5.80 ) or with tool 380000292 (Model
TD5.90, TD5.100 and TD5.110 ). Fix the clutch to the
flywheel with the six bolts.
2. Adjust the coplanarity of the clutch release levers as
described.
3. Clean the distance collar and the mating surfaces of the
clutch housing, and also scrape all residue of old seal-
ing compound from the mating surface of the engine.
4. Spread L
® sealing compound on the mating sur-
OCTITE
faces of the engine and distance collar. Fit the distance
collar on the studs screwed into the engine.
5. Before connecting transmission casing to engine - front
axle assembly, grease discs hubs.
6. Check up the rear wheels with wooden wedges, check
that the hand brake is fully on and that the fixed and
mobile stands are well positioned.
7. Fit and tighten the bolts securing the clutch housing to
the engine.
8. Make sure that no electrical leads or cables are trapped
between the two units.
9. Next rotate the crankshaft by turning the cooling fan,
so as to allow the sleeve to engage the splines on the
power take-off shaft.
10. Remove the stands of tool 380000236 from under the
engine and the gearbox/transmission and the stand
under the draw bar.
11. Refit the cab heater pipe union on the clutch/engine
distance collar. Connect the flexible rubber hoses to
the union.
12. Refit the two power steering cylinder oil delivery and
return connections.
13. Refit the rigit pipe for driwing oil from the transmission
and the metal clamps.
14. Connect the flexible pipe to the injector fuel leak-off
pipe.
15. Fit the electric cable connected to the fuse holder box
and the retaining nut.
16. Fit the electric connections installed on the brake
pump and on the brake fluid reservoir.
17. Fit the cab heater delivery and return pipes and insert
and associated claps.
18. Connect all the electrical connections
19. Connect the throttle cable to the injection pump.
Engine - Engine and crankcase
48012878 21/12/2016
10.1 [10.001] / 12
Advertisement
