Frigidaire FGGF3058RFA Use & Care Manual page 21

Probe (cont'd)
Proper probe placement in food:
• Always insert the probe so that the probe tip rests
inside at the center of the thickest part of meat or food
(See Fig. 1). For best results, do not allow the probe
temperature sensor to contact bone, fat, gristle or the
cookware.
• For bone-in ham or lamb, insert the probe into the
center of lowest large muscle or joint. For dishes such as
meat loaf or casseroles, insert the probe into center of
food. When cooking fish, insert meat probe just above
the gill.
• For whole poultry or turkey, fully insert the probe sensor
into the thickest part of breast area (See Fig. 2).
probe tip
to center of
Insert
food
Fig. 1
Fig. 2
SETTING OVEN CONTROLS
Choosing a setting for how the oven will operate
once the probe reaches the target temperature
Your oven is factory preset to automatically stop cooking
and start the keep warm feature once the probe sensor
reaches the set target temperature. This setting may be
changed to continue cooking if desired.
IMPORTANT
Setting the option for how the oven will heat once the
probe reaches the target temperature must be done
when the oven is inactive. The probe is not required to
be connected to the probe receptacle when setting this
option.
To set the oven to continue cooking after reaching
the target temperature:
1. Press keypad and hold for 6 seconds.
2. Press keypad and toggle until the
message appears (Fig. 3) then press
To set the oven to automatically stop cooking and
start keep warm once reaching target temperature:
1. Press keypad and hold for 6 seconds.
2. Press keypad and toggle until
message appears (Fig. 4) then press
"
Continu
to accept.
Fig. 3
" "
CAnCEL
to accept.
Fig. 4
"
21