Advertisement
FRONT VlEW
HIGH POWER [ml HIGH CURRENT
CAUTION: DO NOT SWITCH
BOTTOM VIEW (PARTIAL)
10
1.
Power
2.
Subsonic, Hawkins Bass Control, H.P. Xover Switch -
pass filter frequency range. Select 'SUB SONIC" to engage the Sub Sonic
filter at 13Hz with no boost. Select "Hawkins Bass Control" to engage the
Sub Sonic filter at 45 Hz with available boost. Select "H.P. XOVER" to engage
the amplifier's high pass filter at 45Hz or 150Hz for running satellite speakers.
3.
Low Pass
at 89Hz.
engaged at the same time.
4.
MONO/SUM/ST Switch
input signal (right channel only). "SUM" for bridged mono operation sum-
ming two input signals (left and right). "ST" for normal stereo operation.
5.
FUSE -
value fuse!
6.
terminal
7.
GND
8.
REMOTE
Speaker Connection Terminal -
9.
10.
Hawkins Bass Control "Boost" Adjustment -
boost when the Hawkins Bass Control circuit is engaged.
11.
Input Levels -
0
RCA Inputs
12.
13.
Crossover S.I.P.'s -
14.
High Power / High Current Switch -
ohm stereo (2 ohms mono).
CAUTION: DO NOT SWITCH WHEN AMPLIFIER
LED -
Indicates amplifier power, either in High Power or Auto High
XOVER Switch -
Selectable low pass filter for driving subwoofers
Note: Do not have the "L.P. XOVER" and the 'HP. XOVER"
Main power supply fuse. Warning: Replace only with the same
Connected to a fuse or circuit breaker, then to the battery's positive
Main ground connection. Bolt to a clean chassis point in the vehicle.
Remote turn-on input from the head unit. Accepts +12V.
Speaker connections for Ch's 1 & 2.
Independent Left and Right input level controls.
Right and Left channel RCA
Crossover frequency settings for amplifier.
Use HIGH CURRENT for loads at 1
11
Selectable high
Varies from 0 to +9 dB of
inputs.
IS
TURNED ON.
Advertisement
