Soundstream Granite 110.2 User Manual
  1. Manuals
  2. Brands
  3. Soundstream Manuals
  4. Amplifier
  5. Granite 110.2
  6. User manual
Soundstream Granite 110.2 User Manual

Soundstream Granite 110.2 User Manual

Soundstream technologies power amplifier user manual
Hide thumbs
1
2
3
4
5
6
7
8
9
Table of Contents

Advertisement

Quick Links

L
C
E
H
0
S
Granite II 0.2
POWER
AMPLIFIER

Advertisement

Table of Contents
loading

Related Manuals for Soundstream Granite 110.2

Summary of Contents for Soundstream Granite 110.2

  • Page 1 SOUNDSTRENvl@ &’ ..-.__ _ _ _ Granite II 0.2 POWER AMPLIFIER...

  • Page 2: Warranty

    Mixed Mono Capable so you can simultaneously drive a stereo and mono load (satellites and subwoofer). 2 Ohm Drive Ability - The Granite amplifiers are designed to drive loads down to 2 Ohms stereo and 4 Ohms bridged. Built-in Staggered Asymmetrical Crossover - Built in 2-way electronic crossover is designed to send either high or low pass information to the 110.2.
  • Page 3 12 dB/octave Passive Crossover Chart Key: L = high quality (DCR ~1 Ohm) inductor/coil C = non-polarized 50 V (or greater) capacitor XXX LOW 8 HIGH PASS DIAGRAMS XXX...
  • Page 4 WIRING You will need the following tools for the wiring of the amplifier: Phillips or slotted screw driver wire strippers wire crimpers When baring the wires for connection to the amplifier, remove 3/8” to l/2” of the insulation. For the speaker leads, use the supplied l/4” insulated female crimp connectors and slide the connector onto the terminal on the amplifier.

  • Page 5: Troubleshooting

    TROUBLESHOOTING PROBLEM No sound and LEDs are not lit Repeatedly blown amp fuse or frequent activation of thermal shut-off CAUSE no power or ground at amp no remote turn-on signal blown fuse near battery blown power supply fuse (accessible through access cover on bottom of amp) speaker or leads may be shorted verify adequate cooling of the...

  • Page 6: Level Setting

    F. Re-connect the fuse or circuit breaker. Power up the system and the red LED should be lit. There may be a 2 -3 second delay from the time that the source unit is turned onto the time that the LED on the amp lights.
  • Page 7 XXX DIAGRAMS XXX BASS EQUALIZATION If the Granite 110.2 is being used to drive a subwoofer, you may want to activate the subwoofer equalization circuit by throwing the switch to the “XXX” position. Activating the circuit also engages a subsonic filter at 45 Hz.

  • Page 8: Passive And Electronic Crossovers

    This amplifier, in conjunction with another amplifier, will competently drive an entire bi-amplified system. If you plan to use the Granite 110.2 in the Mixed Mono configuration, it is important to use the appropriate passive crossovers. Below are charts for 6 and 12 dB/octave crossovers.

  • Page 9: Design Features

    OWNER’S MANUAL & INSTALLATION GUIDE CONGRATULATIONS You now own the Soundstream Granite 110.2 Amplifier, the result of a unique design and engineering philosophy. To maximize the performance of your system, we recommend that you thoroughly acquaint yourself with its capabilities and features. Please retain...

Table of Contents