Defrosting Of The Appliance /5 - Beko HSM20530 Instructions Of Use

Table of Contents

Advertisement

Available languages

Available languages

EN
Freezing with Superfrost
• Place the knob to super frost position. The
Superfrost lamp comes on.
• Wait 24 hours.
• Place the fresh food in the freezer. In order
to achieve fast freezing, food should be in
contact with the interior walls when it is placed
in the freezer.
• The Superfrost facility automatically switches
the fast freezing procedure off after 50 hours.
Important
When you place the knob to Superfrost
position, the compressor might not switch on
for a few minutes. This is due to the integrated
rise-delay switch which is designed to
increase the life span of the refrigeration unit.
You should not switch on the Superfrost
function:
- when placing frozen food in the freezer;
- when freezing up to approx. 2 kg fresh food
daily.
Defrosting of the appliance
We advise you to defrost the freezer at
least twice a year or when the ice layer has an
excessive thickness.
The ice build-up is a normal phenomenon.
The quantity and the rapidity of ice build-up
depends on the ambient conditions and on the
frequency of the door opening.
We advise you to defrost the appliance
when the quantity of frozen food is the least.
Before defrosting, adjust the thermostat
knob to a higher position so that the food
stores more cold.
- Unplug the appliance.
- Take out the frozen food, wrap it in several
sheets of paper and put them in refrigerator or
a cool place.
Use a tray and put it under the freezer in the
direction of the dripping tube. Take out the
obstructing plug. The water which results will
be collected in the tray. After the melting of the
ice and the run-off of the water please wipe
with a cloth or with a sponge, then dry well. Put
the obstruction plug back in its place. (Item. 6)
For a fast thaw please leave the door open.
Do not use sharp metal objects to remove
the ice.
Do not use hairdriers or other electric
heating appliances for defrosting.
Inside cleaning
Before starting the cleaning, unplug the
appliance from the mains.
It is advisable to clean the appliance when
you defrost it.
Wash the inside with lukewarm water
where you add some neutral detergent. Do
not use soap, detergent, gasoline or acetone
which can leave a strong odour.
Wipe with a wet sponge and dry with a soft
cloth.
During this operation, avoid the excess of
water, in order to prevent its entrance into the
thermal insulation of the appliance, which
would cause unpleasant odours.
Do not forget to clean also the door gasket
especially the bellow ribs, by means of a
clean cloth.
Outside cleaning
Clean the outside of the freezer by means
of a sponge soaked in soapy warm water,
wipe with a soft cloth and dry.
The cleaning of the outside part of the
refrigerating circuit (motorcompressor,
condenser, connection tubes) will be done
with a soft brush or with the vacuum-cleaner.
During this operation, please take care not to
distort the tubes or detach the cables.
Do not use scouring or abrasive materials !
After having finished the cleaning, replace
the accessories at their places and plug in the
appliance.
5
Instruction for use

Advertisement

Table of Contents
loading

Table of Contents