Epson TM-U220 Series User Manual page 14

English
No LED on the control panel
❏ Check the power supply cable connections and the power outlet.
ERROR LED is flashing or lit
❏ The print head temperature may be too high or low. Wait until the print
head cools or warms and the printer resumes printing automatically.
❏ Make sure that the roll paper cover is properly closed.
❏ Types A and B: The autocutter blade is not in the normal position and the
autocutter is locked up. If it is a simple lock-up, the error is corrected
automatically. If not, see the instructions below to return the blade to the
normal position manually.
❏ A paper jam has occurred. To remove the jammed paper, see the
instructions below.
❏ Turn off the power, wait several seconds, and then turn it on again. If the
error remains, contact your supervisor or a qualified service person.
Returning the autocutter blade to the normal position
1. Open the roll paper cover by using the tab, as shown in illustration H.
2. Use a ballpoint pen or tweezers to turn the knob of the autocutter in the
direction indicated by the arrow until you see a round shaft in the hole, as
shown in illustration P.
Removing jammed paper
The print head becomes very hot during printing. Allow it to cool before you reach into the
printer.
1. Open the roll paper cover by using the tab, as shown in illustration H.
2. If you have a
by using the unit open lever, as shown in illustration I.
3. Remove the jammed paper.
4. Re-insert the roll paper and close the roll paper cover.
8 TM-U220 User's Manual
CAUTION:
printer, remove the take-up spool and open the unit
Type A