Page 2
R8 Expansion Module - Smart Card Reader with RS-232/RJ-45 & USB 3.2 Package Contents If any of following items is damaged, please contact your retailer. Smart Card Reader with RS- Screw & Mylar Sponge 232/RJ-45 & USB3.2 module (1+7+1+2+1) Expansion Module - Smart Card Reader with RS-232/RJ-45 & USB 3.2 Screws Screw Type Screw Name...
Page 3
R8 Expansion Module - Smart Card Reader with RS-232/RJ-45 & USB 3.2 Installation This section will guide you on how to install the expansion modules to your tablet Note: Make sure to remove the battery before installing any type of expansion modules.
Page 4
R8 Expansion Module - Smart Card Reader with RS-232/RJ-45 & USB 3.2 1. Connect the rear expansion module harness to the mainboard connector. 2. Place the rear expansion module bracket onto its slot on the lower case. Make sure the cut edge of the bracket is aligned properly with the lower case.
Page 5
R8 Expansion Module - Smart Card Reader with RS-232/RJ-45 & USB 3.2 3. Attach the 3 screws to secure the rear expansion module to the lower case. ISOF-M2X3L, D=4mm, BLACK NI (marked with C): 1 screw. ➢ ISOT-M2.0X4L, D=4.5mm, BLACK NI (marked with D): 2 screws. ➢...
Page 6
R8 Expansion Module - Smart Card Reader with RS-232/RJ-45 & USB 3.2 6. Align by the screw holes and then place the rear expansion module on top of its bracket. 7. Release the 2 rubber doors to access the screws. 8.
Page 7
R8 Expansion Module - Smart Card Reader with RS-232/RJ-45 & USB 3.2 9. Press on the rubber doors by following the order from 1 to 2 to secure them in place. Expansion Module - Smart Card Reader with RS-232/RJ-45 & USB 3.2 Screws Screw Type Screw Name...
Need help?
Do you have a question about the R8 Rugged Tablet Expansion Module Smart Card Reader with RS-232/RJ-45 & USB 3.2 and is the answer not in the manual?
Questions and answers