Table of Contents
Advertisement
DAILY MAINTENANCE
1. I
t is recommended to let forms cool for one-half hour, from the laser printer, before processing. This allows toner to
set on the forms and static electricity to discharge. The FD 402 Jogger is recommended for best results. The Jogger
squares the forms and dissipates heat and static electricity created by laser printers.
2. Clean in-feed tires and fold rollers with Formax recommended roller cleaner & rejuvenator to remove paper dust and
toner. A Formax Cleaner Kit is available from your dealer. A damp cloth with water is the best alternative.
CAUTION: Do not use any chemicals other than the roller cleaner & rejuvenator or water.
CLEANING PROCEDURES:
1. Make sure machine is turned off and unplugged. All folder/
sealers have three infeed tires, four rubber fold rollers and
two metal seal rollers (Fig. 15a).
2. Lift top covers and remove the upper and lower fold tables.
3. Using Formax roller cleaner, spray a new cotton cloth until
the cloth is saturated. Wipe the wet cloth in a back and
forth motion making sure to clean the entire surface of the
infeed tires, fold and seal rollers. Next, use a dry cloth to
wipe off excess toner. The cloth should be covered with
black toner surplus from cleaning the rollers.
4. Run 10-15 sheets of blank copy paper to ensure all cleaner
has been removed from the tires, fold and seal rollers.
Running blank sheets will remove any excess residue of
cleaner on the rollers.
NOTE: If the fold rollers are very dirty, you may use a green
scrubbing sponge, i.e. ScotchBrite, with the roller cleaning
solution.
DO NOT use a scrubbing sponge on the seal rollers. It will
damage the surface. Use ONLY a new cotton cloth and roller
cleaning solution on the seal rollers (Fig. 15b)
Fig. 15a
Seal rollers
Fig. 15b
18
Fold Rollers
Infeed Tires
Advertisement
Table of Contents
