SPECIFICATIONS Top Cover Paper side guides Upper Fold Plate In-feed table Catch Tray Control Panel Lower Fold Plate FUNCTION: The 1506 Pressure Sealer folds and seals many different configurations including C, V, Z and custom folds. It may also use several different sizes of forms. For configuration and/or paper sizes, see listing below.
CONTROL PANEL CONTROL PANEL Counter reset Start icon Counter Stop icon OPERATION 1. Adjust fold plates to desired fold for length of paper (see fold plate adjustment on page 3). To do this, loosen the two thumbscrews (figure 3a & b) on each fold plate. Align center bar (figure 3a & b) so the marks on each side match up.
FOLD PLATE ADJUSTMENT Upper Fold Plate Lower Fold Plate Deflector (for Half Folds) Center Thumbscrews Throat Figure 3a Figure 3b Throat 1. To adjust the first fold remove the top cover to access the top fold plate. If the first fold is too long loosen the two thumbscrews on the upper fold plate and slide the bar down.
5. To reinstall the lower fold plate, slide the plate (with the thumbscrews facing up and throat toward inside of machine, figure 5b) until it rests on the two silver bars (figure 5a) and locks into place (figure 5c). Bars Figure 5a Figure 5b Figure 5c...
Error Screens FD 342 Touch Screen -Error Screens Paper Jam Paper misfeed Paper Out / Paper Mis-Feed / Paper Jam 1. The feeder is empty. Load paper paper into the FD 342 Touch Screen -Error Screens feeder and press the “ “...
2. If toner builds up on the metal sealer rollers, clean the rollers with a lint-free cloth dampened spar- ingly with a mild household cleaner. 3. Clean in-feed wheels and fold rollers with Formax-recommended roller cleaner & rejuvenator (Formax part #203) to remove paper dust and toner. A damp cloth with water is the best alternative. CAUTION: Do not use any chemicals other than the roller cleaner &...
Page 12
TROUBLESHOOTING B. Fold Quality Needs Improving: 1. Make sure paper is squared and installed correctly. Side guides should be evenly balanced and snug against the paper. 2. If folds are still incorrect adjust fold plates (see fold plate adjustment on page 3). C.