Advertisement
Quick Links
Advertisement
Related Manuals for Formax AutoSeal FD 1406
Summary of Contents for Formax AutoSeal FD 1406
- Page 1 AutoSeal ® FD 1406 / FE 1406 FK / FL SERIES OPERATOR MANUAL FIRST EDITION 1/2022...
-
Page 3: Table Of Contents
TABLE OF CONTENTS TOPIC PAGE SPECIFICATIONS, UNPACKING & SET-UP CONTROL PANEL OPERATION FOLD PLATE INSTALLATION, ADJUSTMENT SETTING CUSTOM FOLDS DETERMINING FOLD TYPE ERROR SCREENS DAILY MAINTENANCE, TROUBLESHOOTING... -
Page 5: Specifications, Unpacking & Set-Up
SPECIFICATIONS Top Cover Paper side guides Upper Fold Plate In-feed table Catch Tray Control Panel Lower Fold Plate FUNCTION: The 1406 Pressure Sealer folds and seals many different configurations including C, V, Z and custom folds. It may also use several different sizes of forms. For configuration and/or paper sizes, see listing below. -
Page 6: Control Panel
CONTROL PANEL CONTROL PANEL Counter reset Start icon Counter Stop icon OPERATION 1. Adjust fold plates to desired fold for length of paper (see fold plate adjustment on page 3). To do this, loosen the two thumbscrews (figure 3a & b) on each fold plate. Align center bar (figure 3a & b) so the marks on each side match up. -
Page 7: Fold Plate Installation, Adjustment
FOLD PLATE ADJUSTMENT Upper Fold Plate Lower Fold Plate Deflector (for Half Folds) Center Thumbscrews Throat Figure 3a Figure 3b Throat 1. To adjust the first fold remove the top cover to access the top fold plate. If the first fold is too long loosen the two thumbscrews on the upper fold plate and slide the bar down. -
Page 8: Setting Custom Folds
5. To reinstall the lower fold plate, slide the plate (with the thumbscrews facing up and throat toward inside of machine, figure 5b) until it rests on the two silver bars (figure 5a) and locks into place (figure 5c). Figure 5a Bars Figure 5b Figure 5c... -
Page 9: Determining Fold Type
DETERMINING FOLD TYPE Two Standard Folds 11” “Z” & 11” “C” Refer to page 4 for custom fold setup. Leading glue edge Glue Glue 11” “Z” Fold 11” “Z” Fold Leading glue edge Glue Glue 11” “C” Fold 11” “C” Fold... -
Page 10: Error Screens
Error Screens FD 342 Touch Screen -Error Screens Paper Jam Paper misfeed Paper Out / Paper Mis-Feed / Paper Jam 1. The feeder is empty. Load paper paper into the FD 342 Touch Screen -Error Screens feeder and press the “ “... -
Page 11: Daily Maintenance, Troubleshooting
2. If toner builds up on the metal sealer rollers, clean the rollers with a lint-free cloth dampened spar- ingly with a mild household cleaner. 3. Clean in-feed wheels and fold rollers with Formax-recommended roller cleaner & rejuvenator (Formax part #203) to remove paper dust and toner. A damp cloth with water is the best alternative. - Page 12 TROUBLESHOOTING B. Fold Quality Needs Improving: 1. Make sure paper is squared and installed correctly. Side guides should be evenly balanced and snug against the paper. 2. If folds are still incorrect adjust fold plates (see fold plate adjustment on page 3). C.