Table of Contents
Advertisement
Figure 26. Disconnect the EDP cable, the sensor board cable and the antenna cable
Step 2.
Rotate the LCD module to an angle of more than 90 degrees and place the computer on a flat
surface as shown. Remove six screws and then remove the LCD module.
Figure 27. Remove the LCD module
Screw specifications
M2.5 x L4
Notes: For LCD panel with the factory color calibration feature, do the following to install new color profiles:
• Connect your computer to the network.
• Go to
https://pcsupport.lenovo.com/downloads/x_rite_color_tool
• Unzip to local drive and double-click the ColorTool. EXE file. Then, follow the on-screen instruction to
input the display serial number (shown below) and click "Submit". When the new color profiles are
installed successfully, all steps will be marked with "√".
• Permanent delete ColorTool folder at customer's device after complete the LCD replacement. (Shift +
Delete)
• You will also find the instructions come with the LCD panel FRU.
Number of screws
6
to download the ColorTool.ZIP file.
.
Chapter 4
Removing a FRU or CRU
39
Advertisement
Table of Contents
