DèLonghi PRIMADONNA ELITE ECAM65 75 Series Instructions For Use Manual page 26

GROUND TOO FINE. ADJUST
MILL 1 CLICK WHILE IN
OPERATION
ESC
SELECT A MILDER TASTE
OR REDUCE PRE-GROUND
COFFEE QUANTITY
ESC
INSERT WATER SPOUT
INSERT MILK CONTAINER
INSERT INFUSER ASSEMBLY
PUSH
The grinding is too fine and the coffee is delive-
red too slowly or not at all.
If the water softener filter (C4) is present, an
air bubble may have been released inside the
circuit, obstructing delivery.
Too much coffee has been used.
The hot water spout (C6) is not inserted or is
inserted incorrectly
The milk container (D) is not inserted correctly. Insert the milk container as far as it will go (fig.
The infuser (A19) has not been replaced after
cleaning.
Repeat coffee delivery and turn the grin-
ding adjustment dial (A5) (fig. 13) one click
clockwise towards "7" while the coffee mill is
in operation. If after making at least 2 coffees
delivery is still too slow, repeat the correction
procedure, turning the grinding adjustment
dial another click until delivery is correct (see
section "9.3 Adjusting the coffee mill"). If the
problem persists, make sure the water tank
(A16) is fully inserted.
Insert the hot water/steam spout (C6) in the
appliance and deliver a little water until the
flow becomes regular.
Select a milder taste by pressing "
AROMA" (B6) or reduce the quantity of pre-
ground coffee (maximum 1 measure).
Insert the water spout as far as it will go.
18).
Insert the infuser as described in section "16.9
Cleaning the infuser".
26