Summary of Contents for Rave Sports RAVE EZ Set Ice Rink-200
Page 1
All rights reserved. No part of this publication may be reproduced or transmitted in any form or by any means, electronic or mechanical, including photocopy, recording, or any information storage and retrieval system, without permission in writing from the publisher. Requests should be mailed to RAVE Sports, 3325 Labore Road, Saint Paul, MN 55110...
Table of Contents Product parts and warnings …………..………………………………………1 Placement and Setup….……………………………………………………..4 First Ice…………………………………………………………………………………7 Resurfacing & Removal….……………………………………………………….9 Cleaning and maintenance……………………….…………………………..10 PARTS The RAVE EZ Set Ice Rink includes: 1. Ice Rink Liner 2. (4) Corner Screw Stakes 3. (12) Pivoting Side Support Brackets 4.
Page 3
WARNING: Read these materials prior to assembling and using your RAVE Sports product. Failure to follow these instructions could result in serious injury or death. • Set up and supervision must be done by a mature and knowledgeable adult • Ensure proper set up prior to use •...
Page 4
W A R N I N G • THIS PRODUCT IS ONLY FOR USE ON SNOW / LAND AND OUTDOORS. DO NOT USE ON WATER OR ICE-COVERED PONDS, LAKES, RIVERS OR POOLS. • ALWAYS INSPECT ICE FOR THICKNESS BEFORE USE, AND DO NOT USE IF REPAIR IS NEEDED OR UNSAFE CONDITIONS SUCH AS CRACKS, IRREGULARITIES, OR THIN ICE IS EVIDENT.
Placement & Set Up Consider the following when choosing where to set up and place your RAVE EZ Set Ice Rink: • Site suitability: Place your unit on the most level area possible free from any sharp objects or rocks. Slope should be less than 2 inches over 10 feet.
Page 6
and the longest dimension is running across (perpendicular) to the slope. • Convenience: Place your unit where it can be easily supervised. • Water source: Place your unit where you can easily fill and resurface your EZ Set Ice Rink with tap or well water. NOTE: When using a hose in cold weather do not leave it outside after use.
Page 7
diagonally across from the first corner. Before inserting stake into the ground, pull the ice rink liner taught. Proceed to stake the remaining corners, remembering to pull the liner taught each time before screwing the stake into the ground. 3. Clip in the pivoting side support brackets in the already punched holes around the perimeter of the liner.
4. Be sure that your EZ Set Ice Rink liner is tight to each corner to ensure proper freezing of the ice. FIRST ICE The optimum temperature for freezing your rink is 32 degrees F/ 0 degrees C. Begin filling with water, but do not fill it entirely at once.
Page 9
Your ice rink will start to ice up fairly quickly, but it may be several days before it is thick enough to use depending upon weather conditions and the number of layers needed to get ice to a sufficient thickness across the entire span of the rink area.
NOTE: Removal of the Corner Screw Stakes will not decrease stability of the ice surface. RESURFACING Adding more water to the surface of your RAVE EZ Set Ice Rink and allowing it to freeze will refresh the ice surface smoothly. It is recommended that you avoid resurfacing your ice until late in the afternoon or at night after you are done skating for the day.
RAVE Sports directly. During Use RAVE Sports recommends that you occasionally scrape the surface of the ice with a plastic snow shovel (metal shovels do not work as well) to remove snow, ice chips, and other items as needed.
Page 12
Rave Sports A Revel Match, LLC Company 3325 Labore Road Saint Paul, Minn 55110 800.659.0790 August 2015...
Need help?
Do you have a question about the RAVE EZ Set Ice Rink-200 and is the answer not in the manual?
Questions and answers