Advertisement
3) Peninsular Installation
The suggested framing construction is illustrated.
3)
INSTALL THE GRIP RAIL
INSTALL THE GRIP RAIL
For ADAGIO Bath 731T, 731T-GR
Place the gasket (1) onto the grip rail(2). Make sure the
gasket is matching the contour of the grip rail. Insert
both screws(3) into the holes through the grip rail and
the gasket.
Thread screws (3) into the nut pre-installed on the side
of bathtub. Tighten the screw snugly to secure the grip
rail.
Repeat above procedures for the other grip rail.
731T, 731T-GR
(1)
(2)
(3)
For SOISSONS 940T-GR, 941T-GR, 943T-GR
Place the gasket (6) onto the grip rail (7). Insert the
screw (8). Position the grip rail with gasket so that the
hole lines up with the hole on the nut pre-installed on
the side of bath tub.
Thread the screw (8) into the hole of the grip rail.
Tighten the screw snugly to secure the grip rail. Snap
the cap (9) into each hole. Repeat above procedures
for the other grip rail.
940T-GR, 941T-GR, 943T-GR
(6)
(7)
(8)
(9)
1006291-T01-C
(3)
(1)
(2)
8
(8)
-7-
9
8
7
6
(3)
6
Advertisement
