Advertisement
B. Install Plumbing
CAUTION: Risk of damage to bath bottom and subfloor.
Ensure a watertight seal on the bath drain connections.
1)
For through the floor drain installation, when the bath
is securely positioned, connect the drain to the trap.
See Fig. A.
2) Install the faucet valving and spout tee. Open the hot
and cold water valves, and check the supply
connections for leaks.
3)
Run water into the bath, and check the drain
connections for leaks.
B.
1)
2)
3)
C. Finish Bath Area Construction
NOTE: An access panel is essential for future
maintenance.
Possible framing arrangements are illustrated below.
Use the framing construction appropriate for your
particular bath model. Some modifications may be
needed for other types of construction, if preferred.
If an apron wall without a ledge is desired, the finished
apron wall surface must be 2 mm under the bath rim.
Recommended For Drop-in Models
1) Corner Installation
The suggested framing construction is illustrated.
1)
2) Recess Installation
The suggested framing construction is illustrated.
2)
1006291-T01-C
A
C.
2mm
-6-
Connect Here
Fig. A
A
Advertisement
