Electrolux KDI641723K User Manual page 10

10 www.electrolux.com
4. Assemble the parts, follow the same
procedure backwards.
5. Attach the label with the new type of
gas supply near the gas supply pipe.
You can find this label in the package
supplied with the appliance.
If the supply gas pressure is changeable
or different from the necessary pressure,
you must fit an applicable pressure
adjuster on the gas supply pipe.
3.5 Adjustment of minimum
level
To adjust the minimum level of the
burners:
1. Light the burner.
2. Turn the knob on the minimum
position.
3. Remove the knob, the gasket and the
washer.
1
WARNING!
Pay attention not to damage
the gasket. Do not use sharp
tool to remove it.
WARNING!
Do not use the hob surface
to leverage the gasket. This
can cause damage to the
glass.
4. With a thin screwdriver, adjust the
bypass screw position (A).
A
5. If you change:
• from natural gas G20 20 mbar to
• from liquid gas to natural gas G20
6. Reassemble the washer, the gasket
and the knob.
2
3.6 Electrical connection
• Make sure that the rated voltage and
type of power on the rating plate
agree with the voltage and the power
of the local power supply.
• This appliance is supplied with a
mains cable. It has to be supplied with
a correct plug which can hold the load
liquid gas, fully tighten the bypass
screw in.
20 mbar, undo the bypass screw
approximately 1/4 of a turn.
WARNING!
Make sure to place the
gasket and washer exactly in
their original positions.
WARNING!
Make sure the flame does
not go out when you quickly
turn the knob from the
maximum position to the
minimum position.