Adjusting The Tracking - Toro 72980 Operator's Manual

Figure 57
1. Roll bar in the upright
position
2. Roll-bar knob in the
latched position
3. Pull the roll-bar knob out
and rotate it 90 degrees.
Figure 58
1. Engaged
g228804
4. Rotate the roll-bar knob 90
degrees.
5. Roll-bar knob in the
unlatched position
6. Roll bar in the folded
position
g228981
2. Partially engaged—do not
operate with the roll bar in
this position.

Adjusting the Tracking

1. Disengage the blade-control switch (PTO).
2. Drive to an open flat area, move the
motion-control levers to the N
position.
3. Move the throttle midway between the F
S positions.
LOW
4. Move both motion-control levers all the way
forward until they both hit the stops in the T-slot.
5. Check which way the machine tracks.
6. Engage the parking brake, shut off the engine,
and remove the key.
7. Adjust the stop plates as needed.
•
If the machine tracks to the right, loosen the
bolts and adjust the left stop plate rearward
on the left T-slot until the machine tracks
straight (Figure
•
If the machine tracks to the left, loosen the
bolts and adjust the right stop plate rearward
on the right T-slot until the machine tracks
straight (Figure
8. Tighten the stop plate
Left control lever shown
1. Control lever
2. Bolt
48
-L
EUTRAL
59).
59).
(Figure 59).
Figure 59
3. Stop plate
OCK
and
AST
g010153