Table of Contents
Advertisement
Dust filters are
only required/sup-
plied in selected
regions with ex-
cessive dust.
Installing and Cleaning the Dust
Filter
Installing the Dust Filter
Procedure:
1.
Install two filters.
2.
Turn on the projector then press "Menu", go to "OPTIONS -> Op-
tional Filter Settings -> Optional Filter Installed" and select "Yes".
Cleaning the Dust Filter
We recommends cleaning the dust filter every three
months; clean it more often if the projector is used in a
dusty environment.
Procedure:
1.
Switch off the power to the projector by pressing the "
2.
Disconnect the power cord.
3.
Remove the dust filter slowly and carefully.
4.
Clean or replace the dust filter.
5.
To install the dust filter, reverse the previous steps.
6.
Reset the dust filter counter after replacing or cleaning the dust
filter. Press "Menu", go to "OPTIONS -> Optional Filter Settings ->
Filter Reset"
Turn on the projector, then press "Menu", "OPTIONS -> Optional
Filter Settings -> Optional Filter Installed" and select "No" when
you pull out the dust filter and would not install it again.
Appendices
1
1
2
" button.
53
English
Advertisement
Table of Contents
