Remove The Edp Cable; Remove The Hinges And Hinge Covers (For 15- Inch Models) - Lenovo LOQ 15IRH8 Hardware Maintenance Manual

Remove the EDP cable

Make sure the following FRUs (CRUs) have been removed.
"Remove the LCD module" on page 47
"Remove the LCD bezel (for 15–inch models)" on page 49
"Remove the strip cover (for 16–inch models)" on page 50
"Remove the LCD bezel (for 16–inch models)" on page 50
"Remove the LCD panel" on page 51
Step 1. Remove the tape. Disconnect the sensor board cable connector and the camera board cable
connector. Remove the EDP cable.
Figure 37. Remove the EDP cable
Go to https://support.lenovo.com/partslookup
replacement parts:
EDP cable
Removable tape
Remove the hinges and hinge covers (for 15–inch models)
Make sure the following FRUs (CRUs) have been removed.
"Remove the LCD module" on page 47
"Remove the LCD bezel (for 15–inch models)" on page 49
"Remove the strip cover (for 16–inch models)" on page 50
"Remove the LCD bezel (for 16–inch models)" on page 50
"Remove the LCD panel" on page 51
Step 1. Remove eight screws then remove the hinges.
to look up the Lenovo part numbers of the following
.
Chapter 4 Removing a FRU or CRU
55