Installing The Throttle Wire; Fuel Specification; Operating Your Edger/Trimmer; Correct Engine Operation - Havener Enterprises EVEN CUT Parts & Owner's Manual

Installing The Throttle Wire

1. If the throttle cable is not attached tot he engine carburetor, follow the instructions in the engine
operating manual. Some throttle cables can not be attached before shipping.

Fuel Specification

1. Follow fueling instructions in the engine manual.
DANGER: GASOLINE IS HIGHLY FLAMMABLE AND EXPLOSIVE. DO NOT ADD FUEL
WHILE THE ENGINE IS RUNNING OR IS HOT. KEEP OPEN FLAMES, SPARKS, AND HEAT
AWAY FROM THE FUEL AND STORE FUEL IN CONTAINERS SPECIFICALLY DESIGNED
FOR THAT PURPOSE. ADD FUEL OUTDOORS ONLY. REPLACE GAS CAP SECURELY AND
WIPE UP ALL SPILLED FUEL.
2. Always clean area around fuel cap before removing it to prevent excessive amounts of dirt from
entering fueling system. Also insure that the fuel storage container you are using is clean and in
good condition.
Engine Operation
CAUTION: Before starting engine, become totally familiar with all controls. Read this
Operator's Manual thoroughly. Always check engine oil level before starting engine.

Operating Your Edger/Trimmer

Correct Engine Operation

CAUTION: Always disengage edger/trimmer blade and shut engine off when leaving the
edger/trimmer unattended, even for just a few minutes. Don't allow children or un
authorized persons to operate this machine.

Adjusting Cutterhead Angle

Before starting the engine you must adjust the cutterhead angle. The cutterhead angling lever
enables the operator to position the blade horizontally for trimming or edging in several vertical
positions. The lever is located on the left hand side of the frame.
Cutterhead Angle Adjustment
Never adjust cutterhead angle when engine is running
8