Wheel Positioning; Curb Riding Position - Havener Enterprises EVEN CUT Parts & Owner's Manual

Wheel Positioning

The wheel adjusting spacer should be centered between the wheels when edging in the vertical
position. Wheels must be in the dual position to the right when edging with cutterhead in an angle
position or trimming (horizontal position).
DANGER: DO NOT CHANGE THE WHEEL POSITION WHEN THE ENGINE IS RUNNING.
1. Remove the spacer from between the wheels by lifting on the spacer with open side down.
2. Slide the left front wheel on the axle toward the right wheel and install he spacer on the axle
between the frame and the wheel.
CAUTION: Before starting the engine be sure the wheels and cutter head are positioned
so the blade will not strike the wheels.

Curb Riding Position

1. Remove the spacer from between the front wheels. Slide the right wheel toward the left wheel
and replace the spacer between the wheel and right frame. Only vertical edging can be done in
this position.
NOTE: As pictured above, wheels are positioned to the right for trimming. The wheels are
positioned to the left for curb trimming/edging.
10