Assembly; Attaching The Handle; Fill Engine With Oil - Havener Enterprises EVEN CUT Parts & Owner's Manual

NOTE: Reference to Left or Right side of the machine is from the operator's position at the handle,
facing for-ward.
The edger, except the handle and throttle control is fully assembled, packed and shipped in one
carton.

Attaching The Handle

1. Remove handle brace, nuts, and bolts. Align the handle, lower support, ad handle brace holes.
Use all six nuts and bolts. Leave bolts loose until steps 2 and 3 are completed (Figure 1).
2. Install control rod into upper and lower pivot holes and secure with cotter pins (Figure 1). Oil
pivots lightly before installing rod.
3. Move clutch-depth lever into rear notch of quadrant on handlebars. Move cutterhead angling
lever to top notch of quadrant.
4. Remove spark plug wire from spark plug. Move throttle to "OFF" position. Check clutch
operation by pulling recoil starter rope. If blade turns when depth lever is in top notch, loosen
handles bolts and pull towards operator. Tighten bolts and check clutch operation again.
5. Slip on handle grips.
NOTE: Make sure blade does not turn when lever is in top notch-disengaged.
Figure 1

Fill Engine With Oil

NOTE: There is no oil in engine crankcase.
1. Follow instructions in the engine manual for correct grade of oil, oil filling and oil changing
2. Do not mix oil with gasoline.

Assembly

7