Philips D275 User Manual page 39

Activate or deactivate the remote
access
You can allow or block remote access to the
answering machine.
1
Press .
2
Select [ANS. MACHINE] > [TAM
SETTINGS] > [REMOTE ACC.], then press
to confirm each selection.
3
Select [ON] to activate the remote access
or [OFF] to deactivate the remote access,
then press
The setting is saved.
Change the PIN code
1
Press .
2
Select [ANS. MACHINE] > [TAM
SETTINGS] > [CHANGE PIN], then press
to confirm each selection.
3
Enter the old PIN, then press
confirm.
4
Enter the new PIN code, then press
to confirm.
5
Enter the new PIN code again, then
press to confirm.
The setting is saved.
Access the answering machine
remotely
1
Make a call to your home number with a
touch tone phone.
2
Enter * when you hear the outgoing
message.
3
Enter your PIN code.
Default PIN is 0000. You will hear a
single confirmation beep if the PIN is
accepted, and you then need to press
5 to start playing any messages.
to confirm.
to
Note
• The * must be entered while the outgoing
message is still playing, and the PIN
should follow without any delays.
• If the PIN is entered incorrectly, you will
hear three error beeps, and you can
try again, but if it happens three times
consecutively, the line will be released
automatically.
4
Press a key to carry out a function. See
the Remote access commands table
below for a list of available functions.
Note
When there is no message, the phone
hangs up automatically if no key is pressed
in 8 seconds.
Remote access commands
Key Function
2 Delete the current message.
4 Press once to repeat the current
message from the beginning.
Press twice to listen to the
previous message.
5 Listen to messages.
6 Listen to the next message.
7 Switch the answering machine
on (not available when you
listen to the messages).
8 Stop the current message.
9 Switch the answering machine
off (not available when you
listen to the messages).
EN 39