Table of Contents
Advertisement
Home >
Network
>
Advanced Network Features
LDAP Search Using Your Machine's Control Panel
Perform an LDAP Search Using Your Machine's Control Panel
After you configure LDAP settings, you can use the LDAP search feature to find fax numbers or email addresses
to use for:
•
Sending a Fax (not available for DCP models)
•
Sending an Internet Fax (I-Fax) (not available for DCP models)
•
Scanning to Email Server
•
The LDAP feature supports LDAPv3.
•
The LDAP feature does not support SSL/TLS.
•
You may need to use Kerberos Authentication or Simple Authentication to connect to your LDAP server,
depending on the security policy set by your network administrator.
•
You must configure the SNTP protocol (network time server), or you must set the date, time and time
zone correctly on the control panel for Kerberos authentication.
1. Press
to search.
2. Enter the initial characters for your search using the LCD.
3. Press [OK].
The LDAP search result will be shown on the LCD; the
the email (local) address book search results.
•
If there is no match on the server or the email (local) address book, the LCD displays [Results cannot
be found.] for about 60 seconds.
4. Swipe up or down or press a or b to display the name you want.
5. Press the name.
To view the details of the name, press [Detail].
6. If the result includes more than one fax number or email address, the machine will prompt you to select just
one. Press [Apply]. Do one of the following:
•
If you are sending a fax or an I-Fax, press [Fax Start].
•
If you are scanning to the Email Server, load your document, press [Next], and then press [Start].
Related Information
•
Configure and Operate LDAP Search
Related Topics:
•
Synchronize Time with the SNTP Server Using Web Based Management
>
Configure and Operate LDAP Search
icon appears before the fax number (local) or
> Perform an
399
Advertisement
Table of Contents
