Setup - Yamaha XMV4280 Owner's Manual

Setup

This chapter explains how to set up the XMV to input analog signals.
If you are using the XMV along with the MTX, refer to the "MTX Setup Manual."
NOTE
Refer to this manual for details regarding the following items, even if you are using the XMV along with the MTX.
• Making settings for speaker output
• Connecting the speaker output connectors
• Making high pass filter (HPF) settings
• Lowering the brightness of the indicators and the display
• Locking the panel
Here we will make and verify the input/output settings as out-
lined below.
Explanation
Rack-mounting the unit
Checking the device setup DIP switch settings
Connecting the analog inputs (Euroblock)
Making settings for speaker output
Connecting the speaker output connectors
Connecting the power cord
Turning the power on
Enabling analog input
Making high pass filter (HPF) settings
Checking the wiring
Lowering the brightness of the indicators and the
display
Locking the panel
CAUTION
Steps earlier than "Turning the power on" must be per-
formed with the power off. If you perform these steps with
the power on, the settings might not be applied, or you
might be subject to electrical shock if you touch the con-
nectors.

Rack-mounting the unit
Refer to "Precautions for Rack Mounting" (page 7), and
mount the XMV in your rack.

Checking the device setup DIP switch set-
tings
Make sure that all of the rear panel's device setup DIP
switches are in the upward position.
1 2 3 4
Page
13
13
13
14
15
15
16
16
16
17
17
17
5 6 7 8

Connecting the analog inputs (Euroblock)
Connect the analog outputs of your mixer or other device to
the analog input connectors of the XMV.
You must use the supplied Euroblock plugs with tabs.
If these have been lost, please contact your Yamaha dealer.
Cable preparation
approx.
7 mm
approx.20 mm
• To prepare the cable for attachment to a Euroblock
connector, strip the wire as shown in the illustration
using stranded wire to make connections. With a
Euroblock connection, stranded wires may be prone
to breakage because of metal fatigue due to the
weight of the cable or due to vibration. Bundle the
cables and the Euroblock tabs using the supplied
cable ties (page 14). When rackmounting your
equipment, use a lacing bar when possible to bun-
dle and fasten the cables.
NOTE
Do not tin (plate with solder) the exposed end.
• If cables will be frequently connected and discon-
nected, as in the case of a portable installation, we
recommend that you use ferrules with insulation
sleeves. Use a ferrule whose conductor portion has
an external diameter of 1.6 mm or less, and a length
of approximately 7 mm (such as the AI0,5-6WH
made by the Phoenix Contact corporation).
1.6 mm or less
approx.
7 mm
XMV4280/XMV4140
13
Owner's Manual