Task Flow - Sony PCWA-C100 Operating Instructions Manual

Task flow

To build a wireless LAN environment, you must configure both the Access
Point and the Wireless LAN PC Card.
Required tasks depend on the state of your Access Point and Wireless LAN
PC Card. The table below lists the states of the Access Point and Wireless
LAN PC Card, and the tasks required for building a wireless LAN
environment.
Access
Point
*1 See "Connections" on page 13 in the Access Point Operating Instructions manual.
*2 See "Inserting the Wireless LAN PC Card" on page 13 and following sections in this
manual.
*3 See "To establish communication with the Access Point" on page 15 and succeeding
sections in this manual. For further information, see the Wireless Palette Help file.
*4 See "To set up the computer name and workgroup" on page 17 in this manual.
*5 See "Installing software" on page 19 in this manual.
*6 See "Setting up the Access Point" on page 24 and following sections in this manual.
Wireless LAN PC Card
New
1. Connect the Access Point.
(*1)
2. Insert the Wireless LAN
PC Card into a computer.
(*2)
3. Establish communication
with the Access Point.
New
(*3)
4. Set up the computer name
of your computer. (*4)
5. Install the software. (*5)
6. Configure the Access
Point using the Basic
Setup Utility. (*6)
1. Insert the Wireless LAN
PC Card into a computer.
(*2)
2. Establish communication
with the Access Point.
In use
(*3)
3. Set up the computer name
of your computer. (*4)
4. Install the software. (*5)
In use
1. Connect the Access Point.
(*1)
2. Establish communication
with the Access Point.
(*3)
3. Configure the Access
Point using the Basic
Setup Utility. (*6)
• To communicate with an
Access Point previously
used in another wireless
LAN environment from a
computer containing the
Wireless LAN PC Card.
1. Establish communication
with the Access Point.
(*3)
7