Specifications; Before Operation - Nakayama ES3010 Manual

EN

SPECIFICATIONS

Main Parts (Img. A)
1. Rotary plate
2. Supporting base
3a/3b. Mounting screws (with spring)
4. Chain stop
5. Guide plate
6. Guide rail
7. Locking nut
8. Setting screw (for grinding depth)
9. Grinding wheel (100 x 10 mm)
10. Cover
11. Handle
12. Switch
13. Grinding head
14. Screw M4 X 12
15. Nut M8, self-locking
16. Flange
17. Safety label
18. Protective cover

BEFORE OPERATION

To achieve optimal operation of the tool, follow all instructions given.
Before operating the tool, you have to mount the rotary base and set up your device securely.
Assembling the rotary base
1. Place the rotary plate (1) onto the supporting base (2).
2. Thread the mounting nut (7) on the locking screw.
Mounting the chain sharpener on a workbench
For secure handling, the device must be mounted along the edge of a workbench or table.
Use all three fixing points if possible. Make sure that the groove for the saw chain remains free and the locking nut remains accessible.
Note: It is recommended to install an additional rubber pad (not included) in order to reduce noise and vibration emissions.
The screws and nuts required for mounting the tool are not included in the scope of delivery.
Use the following for this purpose:
1. Hexagonal screw M8
2. Washer Ф8mm
3. Hexagonal nut M8, self-locking
Place the tool on an even, clean and dry surface, free of vibrations, that can withhold its weight
and where there is adequate light.
OPERATION
Note: Before you connect the tool to the power supply make sure that the data on the rating plate are identical to the mains data.
Note: Use an extension cable with a cross section of at least 1,5 mm2.
Switching on
Press "I" on the power switch.
Switching off
To turn off the tool , press "0" on the power switch.
Do not use a power tool when the power switch is not in working order. A damaged switch must be repaired or replaced immediately at an
authorized service center.
6
Technical Data
Model
Voltage/ Frequency
Rated power
No load speed
Wheel diameter
Cable length
Features
* The manufacturer reserves the right to make minor changes to product design and technical specifications
without prior notice unless these changes significantly affect the performance and safety of the products.
The parts described / illustrated in the pages of the manual that you hold in your hands may also concern
other models of the manufacturer's product line with similar features and may not be included in the product
you just acquired.
* To ensure the safety and reliability of the product and the warranty validity, all repair, inspection, repair or
replacement work, including maintenance and special adjustments, must only be carried out by technicians
of the authorized service department of the manufacturer.
* Always use the product with the supplied equipment. Operation of the product with non-provided
equipment may cause malfunctions or even serious injury or death. The manufacturer and the importer shall
not be liable for injuries and damages resulting from the use of non-conforming equipment.
WWW.NIKOLAOUTOOLS.GR
ES3010
230 V / 50 Hz
220 W
8500 rpm
100 x 10 x 3.2 mm
0.35 m
Plastic base
Rubber pad
Workbench