NETGEAR MR90 User Manual page 100

• Active. A link aggregation LAN device is connected to the LAN Aggregation
ports on your router.
5. To change the LAN port aggregation mode, select one of the following radio buttons:
• Disable. This mode is selected by default. This mode disables LAN port
aggregation on your router. The LAN Aggregation ports can be used as
independent Ethernet ports.
• Enable (LACP-IEEE 803.3ad). After you connect the Ethernet cables, the router
communicates with the LAN device that is connected to the LAN Aggregation
ports on your router, and checks to see if LAN port aggregation is supported on
the LAN device. If LAN port aggregation is supported, the router automatically
trunks the LAN Aggregation ports. If not, the LAN Aggregation ports work as
independent Ethernet ports. We recommend that you select this mode unless
your LAN device can support a static link aggregation group (LAG) only.
• Enable static LAG. If your device supports a static LAG only, select this mode.
Otherwise, we recommend that you select the Enable (LACP-IEEE 802.3ad) radio
button instead.
NOTE: If your LAN device supports a static LAG only, you must enable
static mode on your router before you connect your device to the LAN
Aggregation ports on the router.
6. If you made changes, click the Apply button.
Your settings are saved.
Manage Network Settings
Nighthawk Tri-band Mesh WiFi 6E
100 User Manual