Honda ELECTRIC 2019 Owner's Manual page 449

Charge Lid
Charging Connector
Charge Indicator
Release Button
uuCharginguCharge the High Voltage battery using a Level 1, 2 or SAE J1772 DC charger
5. Open the charge lid.
6. To connect the cable to the vehicle, push
the cable's charging connector until it clicks
to the charge lid.
u The charge indicator on the charge lid
stays on.
■
When charging is completed
Press the release button on the charging
connector to disengage it from the inlet.
The charge indicator goes off once charging is
completed.
1How to Charge (Level 2)
The charge speed slows down towards the
completion of the battery charging.
The charge lid can open by remote transmitter.
The High Voltage battery may not be charged even if
the charge connector is properly connected to the
vehicle's inlet when the charging timer is set but the
timer has not yet started.
Be sure to follow the instructions and safety
precautions provided with the Level 2 charging
equipment.
While the vehicle is charging or is parked after
running, the compressor may operate to melt any
frost that has formed on the climate control system.
Water from the melted frost drains out through the
front section of the vehicle, near the undercover.
If you unplug the charging connector from the inlet,
charging cancels automatically.
Continued 447