Charge The High Voltage Battery Using A Level 1, 2 Or Sae J1772 Dc Charger - Honda ELECTRIC 2019 Owner's Manual

Charge the High Voltage battery using a Level 1, 2 or
SAE J1772 DC charger
There are three ways to charge the High Voltage battery; by using the Level 1 120
volt (12 amp) charger supplied with the vehicle plugged into a standard three-prong
wall outlet, or by using a professionally installed Level 2 240 volt (32 amp) or SAE
J1772 DC (125 amp) charger.
Charging with
SAE J1772 DC
AC 240 V
(Level 2)
AC 120 V
(Level 1)
*1:
Charging time varies depending on conditions, such as the remaining battery level and the ambient
temperature.
The suggested full charging time in this table indicates the hours it may likely take
for the High Voltage battery to be fully charged from the moment the low charge
indicator comes on with the ambient temperature at 77°F (25°C).
uuCharginguCharge the High Voltage battery using a Level 1, 2 or SAE J1772 DC charger
Suggested charging time
30 minutes (80% charge) *1
3.5 hours (full charge) *1
19 hours (full charge) *1
Continued
1Charging
WARNING
3
Improper usage and handling of the 120
volt charger can cause a fire, seriously
injuring you or others.
• Always insert the plug fully into a
properly rated and grounded the wall
outlet.
• Plug the charging cable directly to the
wall outlet. Do not use extension cords or
multi-plug adapters.
• Prevent the vehicle charging connector
from becoming contaminated. Clean if
necessary.
When the battery warming system is activated, the
battery may take longer to charge.
When the 12-volt battery is disconnected, vehicle
charging is not possible. After reconnecting the
battery, turn the power system on, then turn it off.
Confirm that charging is possible.
2 Turning on the Power P. 368
443